CKZSJ - KODAK SUPRALIFE, PHOTOLIFE ALKALINE BATTERY SIZE: K3A, K3A-P
- MSDS: CKZSJ
- Manufacturer: EASTMAN KODAK COMPANY
- Product Name: KODAK SUPRALIFE, PHOTOLIFE ALKALINE BATTERY SIZE: K3A, K3A-P
- National Stock Number: 6135-00-900-2139
Product Identification
Product ID:KODAK SUPRALIFE, PHOTOLIFE ALKALINE BATTERY SIZE: K3A, K3A-P
MSDS Date:03/03/1992
FSC:6135
NIIN:00-900-2139
Status Code:A
MSDS Number: CKZSJ
Responsible Party
ROCHESTER, NY 14650
US
Emergency Phone: 7167225151
Info Phone: 716-722-5151
Cage: 19139
Contractor
Telephone: 716-722-5151/(800) 242-2424
Cage: 19139
Ingredients
37% -
RTECS: PS1006506
Fraction By Weight: 6%
MERCURY
CAS: 7439-97-6
RTECS: OV4550000
Fraction By Weight: .001%
OSHA PEL SEE TABLE Z-2
ACGIH TLV: 0.025 MG/M3
EPA Report Quantity: 1 LB
DOT Report Quantity: 1 LB
Hazards
Medical Cond Aggravated by Exposure:
First Aid
First Aid:SKIN: IMMEDIATE.SLY FLUSH WITH PLENTY OF WATER FOR AT LEAST
15 MINUTES. IF SYMPTOMS
ARE PRESENT AFTER FLUSHING, GET MEDICAL ATTENTION. EYES: IMMEDIATELY
FLUSH WITH
PLENTY OF WATER FOR AT LEAST 15 M INUTES AND GET MEDICAL ATTENTION.
BATTERY
INGESTION: OBTAIN IMMEDIATE MEDICAL ATTENTION.
Fire Fighting
Extinguishing Media:USE AN EXTINGUISHING MEDIUM APPROPRIATE FOR THE
SURROUNDING FIRE.
Fire Fighting Procedures:USE A POSITIVE PRESSURE SELF-CONTAINED
BREATHING APPARATUS IF BATTERIES ARE INVOLVED IN A FIRE. FULL
PROTIVE CLOTHING IS NECESSARY.
Unusual Fire/Explosion Hazard:BATTERIES MAY RELEASE TOXIC MERCURY
VAPORS AND/OR IRRITAING POTASSIUM HYDROXIDE FUMES IF EXPOSED TO
FIRE OR HIGH TEMPERATURES. BATTERIES MAY VENT IF EXPOSED TO
EXCESSIVE HEAT OR FIRE.
Handling
Handling and Storage Precautions:DO NOT STORE BATTERIES IN A MANNER
THAT ALLOWS TERMNLS TO SHORT CIRCUIT. STORE
BATTERIES IN A COOL (BELOW 70F), DRY AREA THAT IS SUBJCT TO LITTLE TEMP
CHANGE. DO NOT
PLACE NEAR HEATING EQPMENT, NOR EXPSE TO DIRCT SUNLIGHT FOR LONG
PERIODS. ELEVATED
TEMPS CAN RESULT IN REDCED BATTERY SERVCE LIFE.
Exposure Controls
Supplemental Safety and Health
Chemical Properties
HCC:N1
Solubility in Water:INSOLUBLE
Appearance and Odor:9V BATTERY
Disposal
Waste Disposal Methods:CONSULT LOCAL, STATE AND FEDERAL ENVIRONMENTAL
PROTECTION AUTHORITIES FOR THE
MOST CURRENT REGULATIONS REGARDING DISPOSAL OF BATTERIES. DO NOT
INCINERATE OR
EXPOSE BATTERIES TO FIRE.
Toxicology
Toxicological Information:ALKALINE BATTERIES ARE NOT DESIGNED TO BE
RECHARGED. CHARGING AN ALKALINE BATTERY MAY RESULT IN ELECTROLYTE
LEAKAGE AND/OR VENTING. NEVER DISASSEMBLE A BATTERY. SHOULD A
BATTERY UNINTENTIONALLY BE CRUSHED THUS RELEASING ITS CONTENTS,
RUBBER GLOVES MUST BE USED TO HANDLE ALL BATTERY COMPONENTS. IN
THE EVENT OF SKIN OR EYE EXPOSURE TO THE ELECTROLYT REFER TO FIRST
AID INFORMATION.*
Other Information
Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.
Ecology
Ecological:*MORE THAN A MOMENTARY SHORT CIRCUIT WILL GENERALLY REDUCE
THE BATTERY SERVICE LIFE. EXTENDED SHORT CIRCUITING CREATES HIGH
TEMPERATURES IN THE CELL. HIGH TEMPERATURES CAN CAUSE SKIN BURNS
AND CAUSE THE CELL TO VENT.**
Transport
Transport Information:**THE USE OF OLD AND NEW BATTERIES OR BATTERIES
OF VARYING SIZES AND TYPES IN THE SAME BATTERY ASSEMBLY SHOULD BE
AVOIDED. THE BATTERIES ELECTRICAL CHARACTERIESTICS AND
CAPABILITIES VARY AND DAMAGE M AY RESULT TO THE BATTERIES OR
ELECTRICAL EQUIPMENT.***
Regulatory
SARA Title III Information:THE USE OF OLD AND NEW BATTERIES OR
BATTERIES OF VARYING SIZES AND TYPES IN THE SAME BATTERY ASSEMBLY
SHOULD BE AVOIDED. THE BATTERIES ELECTRICAL CHARACTERISTICS AND
CAPABILITIES VARY AND DAMAGE MAY RESULT TO THE BATTERIES OR
ELECTRICAL EQUIPMENT. USE NICKEL PLATED STEEL (OR STAINLESS STEEL)
FOR POWER TERMINAL CONTACTS. DO NOT DIRECTLY SOLDER TO THE
BATTERY. MAY CAUSE VENTING AND/OR EXPLOSION. AVOID ENCASING
BATTERIES IN AIRTIGHT COMPARTMENTS. FLAMMABLE HYDROGEN GAS,
NORMALLY GENERATED, CAN FORM EXPLOSIVE MIXTURES. PROVISIONS FOR
VENTING MUST BE PROVIDED. NEVER COMPLETELY ENCAPSULATE A BATTERY.
TO DO SO WILL INHIBIT THE SA
State Regulatory Information: